Publicidad
Idiomas disponibles
Idiomas disponibles
Deutsch
English
7.7.1 Activation
Upon delivery, NB-IoT module has a standard configuration. To change
the configuration, please download the OTC Application (One-Touch com-
missioning) for Android, available in Google Play store.
The OTC connects to the module via NFC.
Make sure to locate the NFC antenna on your phone. When you
scan or write new configurations to the module, you should place
the phone's NFC antenna as close as possible to the NFC antenna
of the module. The NFC is reachable from back side of the meter or from
top when lid is removed.
By default, the product is set to passive mode, which means no messages
will be transmitted from the device. There are two ways to activate the
product:
ƒ
Press and hold down the push button (5) for at least 5 seconds until
the green LED (1) lights up.
ƒ
Via the OTC mobile application. Go to the Apply tab, set the Power
mode to "Active", push "Apply" and place the phone on the back side
of the meter, next to the module. Make sure to hold the phone still
until the phone vibrates.
Upon start-up, the module will attempt to connect to the mobile network.
The phase is indicated by short flashes on the green LED. After success-
fully connecting to the mobile network, the green LED will light up for 8
seconds, as indicated by the figure below.
1s
8s
-47-
Publicidad
