Publicidad
Idiomas disponibles
Idiomas disponibles
Deutsch
English
Radio characteristics
Frequency Band
Transmit power (max.)
Receiver sensitivity
LoRa - Version
Activation
7.8.1 Activation
Upon delivery, LoRa WAN module is set to passive mode, which means
no messages will be transmitted from the module. The module can be
activated in one of the following ways:
ƒ
By using the module push button: Press down the push button of the
module for at least five seconds until the green LED lights up.
ƒ
By using the Elvaco OTC App: Open the Elvaco OTC app (downloa-
dable via Google Play) and scan the module (make sure NFC is acti-
vated on the phone). Remove the front enclosure of the meter if
needed. Go to Apply mode, set the Power mode to "active" and click
Apply settings. Place the phone next to the module. New settings are
applied via NFC. You can make sure that the module has joined the
LoRaWAN® network correctly by checking the "network join" field in
the Inspect tab of the OTC App.
Network join
When activated, the module will attempt to join the LoRaWAN® network.
The phase is indicated by short flash on red light, then green and red
LED lights up for 1 second, followed by short flashes on the green LED
until the module has joined the LoRaWAN® network. When the module
succeeds in joining the LoRaWAN® network, the green LED will light up
for 8 seconds, as indicated by the figure below.
1s
868 MHz (occupied bandwidth 200kHz)
13 dBm
-135 dBm
1.0.2
OTAA or ABP
8s
-49-
Publicidad
