Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
Installation
Pease read these instructions carefully
before installing your SimpleSpa Eco.
Failure to do so could result in flooding,
leaking or damage to the product.
1. Existing toilet seat removal
a. Lift hinge covers and use flathead or
Phillips-head screwdriver to remove
the mounting bolts. Alternatively, you
may need to loosen the mounting
bolts underneath the seat.
b. Remove the toilet seat, and set the seat,
mounting bolts, and hardware aside.
Step 1b
2. Turn off water supply valve and flush
toilet
a. Turn off water supply valve to stop the
flow of water.
b. Flush toilet and hold down handle to
completely empty tank.
c. Disconnect water supply hose from
toilet tank; do not disconnect from the
water supply valve.
Step 2c
3. Connect cold water T-Valve to the toilet
tank fill valve
a. Install the 7/8" cold water T-Valve
with one or both of the large rubber
washers to the incoming water
connection on the bottom of your
toilet tank.
b. Connect the cold water supply line
coming from the wall to the bottom of
the T-Valve.
Step 3
4. Connect bidet hose to T-Valve
Connect one end of the braided-metal cold
water bidet hose to the remaining open
side of the installed T-Valve.
Step 4
FOR AMBIENT TEMPERATURE MODEL,
STOP HERE AND PROCEED TO
"INSTALLING THE BIDET ATTACHMENT"
ON PAGE 10. FOR DUAL TEMPERATURE
MODEL, CONTINUE.
7
Publicidad
