Publicidad
Idiomas disponibles
Idiomas disponibles
How to register your boat's MMSI number in your beacon?
The MMSI number can be registered using a smartphone application developed by SIMY, available in the
Google Store (for Android) and Apple Store (for iOS). Programming is done using the smartphone's flash
LED.
Caution: each MMSI registration in the beacon uses up part of its battery. Do not register more
than 2 numbers per year to preserve battery life.
My-MOB
If you wish to regularly test your My-MOB beacon, you can programme the ship's
MMSI number into it.
When running the test, the beacon will send a message to your DSC VHF, which will
receive and display the test message.
towards the little see-through window at the front of the beacon.
Your MMSI number has now been programmed. The whole process can be done
again to change the number if necessary.
In closed-loop mode, the beacon can be programmed to send distress messages to
your ship only. After 12 minutes, without any acknowledgement, the message will in
any case be sent to all nearby ships.
Fill in the boxes below with the 9 MMSI numbers:
4
5
2 8
Closed loop
Programme
Erasing the MMSI no.
The MMSI and "closed-loop" option can be erased from the beacon by pressing longer than 10 seconds
on the T button. The red LED will flash 8 times to confirm the ship's MMSI has been erased and that the
open-loop mode has been activated.
N
4 3
6
1
5
1- Download the application on your smartphone
2- Run the application
3- Enter your boat's MMSI number into the dedicated field
4- If you want, you can activate the closed-loop option by
ticking the appropriate box
5- Take your My-MOB beacon and keep the "T" button
pressed until the LED switches o (about 6 seconds)
Your beacon is now in "programming" mode, awaiting the
MMSI number transmitted by light flashes
6-Position your smartphone's flash against your beacon's
LED zone
7- Press on the "Programme" button in the application. The
camera's flash will then send a light message containing
your ship's MMSI number
After a few seconds, the beacon will beep and flash green.
These signals confirm that your MMSI number has been
properly programmed into your beacon - congratulations
If the beacon switches o after 2 minutes, this means the
operation did not work properly. Run through steps 2 to 8
again using another smartphone if you can, to make sure
the problem does not come from your phone (incompatible
LED flash).
21
Publicidad
