Simy My-MOB Guia Del Usuario página 25

Desactivating your beacon
Once activated, the My-MOB beacon can be stopped at any time by pressing on "T" for at least 3 seconds.
Important: Stay pressed down for at least 3 seconds, until
the red LED flashes 5 times. As soon as the red flashing
starts, you can remove your finger and the beacon will
switch o . The distress signal will no longer be emitted, and
the LEDs will stop working.
Repositioning the antenna under the beacon's cap
If the beacon was activated by mistake, and after having switched it o , please follow the instructions
below to fold the antenna back and put the beacon' s cap back on.
1. Push the antenna vertically downwards; To make this easier, turn the top of the antenna clockwise
(the same way as the spirals) whilst pushing downwards.
2. Keeping the antenna flat and folded away, lift the cap towards the top of the beacon so it goes back
to its initial position
3. Disarm the beacon by blocking the cap with the arming clip
Caution: As there is an activation magnet in the beacon's cap, it may reactivate once the cap is put
back into place. If this happens, hold down the T button until the red LED flashes 5 times, then
release the T button.
24
T
E