Fitnation TREAD04 Manual De Instrucciones página 7

SETUP
1. Place treadmill in an appropriate location
based on the precautions outlined in
Warnings section.
2. Erect handlebar by stepping on handlebar
release lever underneath folded handle
bar (fig. 1). While handlebar is released, lift
handlebar into the upright position until
clicks into place and handlebar release
lever pops up into locked position. It is
not advised to use unit without erecting
handlebars.
3. Plug power cord into treadmill at front
next to red power switch, ensuring plug is
correctly oriented (fig. 2). Plug other end
of power cord into grounded outlet. Turn
on power switch. A sound will chime and
treadmill display will light up and dash
marks will appear on
the display.
4. Install CR2032 battery (included) according
to the polarity indicated on the backside of
the battery cover (fig. 3). For first-time use
or after replacing the battery, press and
hold the remote control's power button
for 5‒8 seconds until the screen displays
3, 2, 1. This will pair the remote control
with the treadmill. Treadmill will NOT
work without remote.
Place safety clip onto handlebar ensuring it
engages the magnet (fig. 4). Attach safety
clip to clothing when using treadmill. If
treadmill needs to be turned off immediately,
remove safety clip from handlebar and
treadmill will automatically stop. To resume
after removing safety clip, place clip back on
handlebar and press power button on remote.
NOTE: Treadmill will NOT run if safety clip is not on handlebar and only dash
marks will appear on the display.
USE INSTRUCTIONS
FIG. 1
FIG. 2
FIG. 3
FIG. 4
7