EGAmaster 79616 Manual De Instrucciones página 56

Continue disassembling inner motor parts L (see fig. 5 and 6).
Remove the snap ring N from the end plate O and press out the grooved ball bearing P (see fig. 6).
Re-assembly of the motor
Basically the re-assembly is done in reverse order than the disassembly. Wear parts,
particularly the vanes, should be replaced. Vanes Q are considered to be worn, when their width
is less than 9.7 mm (see fig. 7).
Disassembly of the handle
Remove snap ring R and pull valve insert S out of the motor housing with handle M. (see fig. 8).
56