Zodiac RF 5400 iQ Guia De Inicio Rapido página 7

Charge
the cleaner
Handle
Bip
1
Connect the charging station to a power
socket.
2 Position the cleaner on the charging station
such that the back of the cleaner makes
contact with the notches provided for this
purpose.
3
Check that the cleaner is charging correctly:
an audible signal is emitted and the
indicator flashes slowly.
•
Charging temperature: 5°C - 35°C.
•
Check that the cleaner is dry before charging.
Start
3
a cycle
Rear
grating
Choose the
mode
1
When the cleaner is fully charged (
remove it from the charging station and carry
it to the pool.
2
Select the mode by sliding the cursor at the
back of the cleaner to the left. The indicator
shows the mode selected.
"Floor/walls/waterline" mode (2h30)
"Floor only" mode (1h30)
Start the cleaning cycle by sliding the cursor
3
at the back of the cleaner to the right. The
indicator flashes until the cleaner is immersed
in water.
Immerse
4
the cleaner
Start the
cycle
green),
1
Immerse the cleaner and hold it underwater
to help remove any air.
2
Let the cleaner sink to the bottom of the
pool. The cycle will start within 40 seconds
after the cleaner detects that it is in water.
5