Beko GN1426234ZDXN Manual De Instrucciones página 5

Important instructions regarding safety and environment
Do not use an extension cord, multi-
plug or adaptor to operate your product.
Portable multi sockets or portable
power supplies may overheat and cause
fire. Thus, do not have a multi-plug
behind or in the vicinity of the product.
The plug shall be easily accessible. If
this is not possible, a mechanism that
meets the electrical legislation and
that disconnects all terminals from
the mains (fuse, switch, main switch,
etc.) shall be available on the electrical
installation.
Do not touch the plug with wet hands.
When unplugging the appliance, don't
hold the power cord, but the plug.
1.4 Handling Safety
This product is heavy, do not handle it
by yourself.
Do not hold the product from its door
while handling the product.
Be careful not to damage the cooling
system and the pipes while handling
the product. Do not operate the product
if the pipes are damaged, and contact
an authorized service.
1.5 Installation Safety
Contact the Authorized Service for
the product's installation. To prepare
the product for installation, see the
information in the user guide and make
sure the electric and water utilities
are as required. If the installation is
not suitable, call a qualified electrician
and plumber to have them make the
necessary arrangements. Otherwise,
electric shock, fire, issues with the
product or injuries may occur.
Check for any damage on the product
before installing it. Do not have the
product installed if it is damaged.
Place the product on a level and hard
surface and balance with the adjustable
legs. Otherwise, the refrigerator may tip
over and cause injuries.
The product shall be installed in a dry
and ventilated environment. Do not
keep carpets, rugs or similar floor
covers under the product. This
may cause risk of fire as a result of
inadequate ventilation!
Do not block or cover ventilation
holes. Otherwise, power consumption
may be increased and damage to your
product may occur.
Do not connect the product to supply
systems such as solar power supplies.
Otherwise, damage to your product
may occur as a result of the abrupt
voltage fluctuations!
The more refrigerant a refrigerator
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m3 of
volume is required for each 8 grams
of refrigerant. The amount of the
refrigerant available in your product
is specified in the Type Label.
The installation place of the product
shall not be exposed to direct
sunlight and it shall not be in the
vicinity of a heat source such as
stoves, radiators, etc.
If you cannot prevent installation of the product
in the vicinity of a heat source, you shall use a
suitable insulation plate and the minimum distance
to the heat source shall be as specified below.
- At least 30 cm away from heat sources such
as stoves, heating units and heaters, etc.,
- And at least 5 cm away from electric ovens.
Your product has the protection
class of I. Plug the product in a
grounded socket that conforms with
the Voltage, Current and Frequency
values specified in the type label. The
socket outlet shall be equipped with a
fuse with a rating of 10 A – 16 A. Our
company shall not be responsible for
the damages that shall be incurred
as a result of operating the product
without ensuring ground and
electrical connections made as per
local or national regulations.
4 / 33 EN
Refrigerator / User Manual