Descargar Imprimir esta página

Cramer 2102286 Manual De Instrucciones página 6

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 16
EN
5
MAINTENANCE
Read and understand the safety regulations and the
maintenance instructions before you clean, repair or do the
maintenance work on the machine.
Make sure that all nuts, bolts and screws are tight. Check
regularly that the handles are firmly mounted.
Use only the replacement parts and accessories of the initial
manufacturer.
5.1
GENERAL INFORMATION
Only your dealer or approved service center can do the
maintenance that is not given in this manual.
Before the maintenance operations:
Stop the machine.
Remove the battery pack.
Cool the motor.
Store the machine in a cool and dry place.
Use correct clothing, protective gloves and safety glasses.
5.2
CLEAN THE MACHINE
Clean the machine after each use with a moist cloth
dipped in neutral detergent.
Do not use aggressive detergents or solvents like "glass
cleaner" to clean the plastic parts or handles.
Keep the trimmer head free from grass, leaves, or
excessive grease.
Keep the air vents clean and free of debris to avoid
overheating and damage of the motor.
Do not spray water onto the motor and electrical
components.
5.3
REMOVE THE REMAINING LINE
Figure 9 - 11.
1. Simultaneously press the tabs on the sides of the trimmer
head.
2. Pull and remove the spool cover.
3. Remove any remaining line.
4. Clean dirt and debris from all parts.
5. Align the spool tabs with the tab openings in the base of
the spool.
6. Push the spool cover until it clicks into position.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
English
5.4
INSTALL THE CUTTING LINE
Figure 12 - 15.
Do not put more than 15 feet of cutting line in at a time.
1. Line up the slots on the spool cap with the slots on the
trimmer head.
2. Put the cutting line through the hole. Push the cutting line
until it exits the opposite hole.
3. Pull the cutting line through until there is an equal
quantity of cutting line on each side.
4. Turn the spool cap clock-wise to wind the cutting line
into the trimmer head. Keep approximately 5 in of cutting
line above out of each side of the trimmer head.
5.5
REMOVE THE TRIMMER HEAD
Figure 16.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Turn the trimmer head clockwise to loosen it. Do not
remove the spacer from the shaft.
5.6
ASSEMBLE THE TRIMMER HEAD
Figure 16.
1. Put the metal rod in the specified angle transmission hole
to fix the trimmer head.
2. Assemble the trimmer head.
3. Turn the trimmer head counterclockwise to tighten it.
4. Remove the metal rod.
You must install the cut-off blade when you use the trimmer
head.
6
TRANSPORTATION AND
STORAGE
6.1
MOVE THE MACHINE
When you move the machine, you must:
Wear gloves.
Stop the machine.
Remove the battery pack and charge it.
Assemble the blade guard.
6.2
STORE THE MACHINE
Remove the battery pack from the machine.
Make sure that children cannot access the machine.
Keep the machine away from corrosive agents such as
garden chemicals and de-icing salts.
6
NOTE
IMPORTANT

Publicidad

loading

Este manual también es adecuado para:

82t15