Publicidad
Idiomas disponibles
Idiomas disponibles
Maxeon specified or Maxeon supplied mounting systems.
5)
Modules mounted with strict adherence to Maxeon
documentation, using hardware systems supplied by or
specified by Maxeon.
Figure 2 and Table 1.1 below demonstrate the mounting locations and
Tables 1.2 and 1.3 give allowed load ratings (designed test value) for
Maxeon modules.
Figure 2: Mounting Zone locations for Maxeon modules
For P‐Series, MAX3 96, 104, 112 cells and MAX6 66 cells:
For 128 cells, P‐Series and MAX5/MAX6 Commercial:
Table 1.1: Approved module clamping/direct fixation zones
Mounting zone distance from
Module Configuration
Frame
Module size
type
(1&2&3&4)
G3
(Black)
96 cells, 104
Silver &
50‐350
cells (MAX2,
G4.1 &
MAX3), 112
G4.2 &
cells, P3 BLK
G4.3
and P3 RES+
G4 &
128 cells and
G4.1 &
50‐350
P19‐COM
G4.2
G4.2 &
P3‐COM
50‐350
G4.3
MAX6 (66 cells)
G5.2
50‐350
MAX5 and
G4.2 &
MAX6 COM
50‐350
G5.6
(72 cells)
D ‐ There is a 20mm zone at 388‐408mm from the corner where mounting is not
allowed due to the module stacking pin feature. Applicable to 128 and 96 cell
commercial only.
1) No part of the module clamp may extend beyond this area.
© June 2022 Maxeon Solar Technologies, Ltd. All rights reserved. Specifications included in this manual are subject to change without notice.
Frame
1
corner in (mm)
holes
A
B
C
(1&2&3&4)
(1&2&3&4)
(1&2&3&4)
150‐380
50‐150
408‐880
50‐375
Drawing in
the Table 2
408‐833
50‐375
265‐514
50‐265
296‐536
50‐296
Safety and Installation Instructions ‐ Document 001‐15497 Rev.X
Figure 3: Mounting Configurations
Configurations 1 and 2 show mounting with rail support, 3 and 4
show mounting without rail support. In "With Rail Support" the rails
becomes conventional or rails transverse while "Without Rail
Support" becomes end mounted in long or short side. In the case
when the glass deflects it would not deflect in the rails for additional
support.
Table 1.2: Mounting Zone Design Load Ratings for Racking system
without rail support underneath the module. Refer to configuration
3 and 4 in Fig.3
Module
Configuration
Module
Frame
size
Black &
Silver &
96 cells,
G4.1 &
and P3 BLK
G4.2 &
104 cells
(MAX2,
MAX3) and
112‐cells
(MAX3)
P3 RES+
G4 &
128 cells,
G4.1 &
P19‐COM
G4.2 &
E
P3‐COM
MAX6 (66
cells)
MAX5‐
COM
(72 cells)
MAX6‐
COM
(72 cells)
As per
(*): 5400Pa is allowed with clamps and mounting rails along the longer side of the frame
(**): 2400/2400Pa are allowed with clamps and mounting rails along the longer side of
the frame
For Rooftop application 1200/1200Pa is allowed with only clamps
(***) Safety factor of 1.5 included
MAXEON SOLAR TECHNOLOGIES, LTD.
Wind (up & down) / Snow (down)
(units in Pa) (***)
End
Frame
Mount
Holes
B
type
A
E
(1&2&3&4)
(1&2&3&4)
(1&2&3&4)
G3
2400/
(*)
2400
2400/
2400/
G4.3
5400
5400
1800/
G4.2
1800
1300/
1600/
1600/
G4.3
1600
2400
2400
Not
2400/
3600/
applicable
5400
3600
(**)
G4.2
1600/
1600/
1600/
G4.3
1600
2400
2400
1600/
3600/
3600/
G5.2
1600
3600
3600
1600/
G4.2
1600
3600/
3600/
3600
3600
1067/
G5.6
1200
C
(1&2&3&4)
or B + C
(B
+C
or
B
+C
)
1&3
2&4
2&4
1&3
Or A + B
(A
+B
or
A
+B
)
1&3
2&4
2&4
1&3
Or A + C
(A
+C
or
A
+C
)
1&3
2&4
2&4
1&3
2400/2400
1300/
1600
2400/2400
1600/1600
1600/1600
1600/1600
Publicidad
