Jocel JCH-100 Manual De Instrucciones página 64

Caution! Before troubleshooting, disconnect the power supply. Only a
qualified electrician of competent person must do the troubleshooting that
is not in this manual.
Important! There are some sounds during normal use (compressor,
refrigerant circulation).
Problem
Appliance dose
not work
Appliance freezes
too much
The food is not
frozen enough
Heavy build-up of
frost on the door
seal.
Unusual noises
If the malfunction shows again, contact the Technical Assistance.
These data are necessary to help you quickly and correctly. Write the necessary
data here, refer to the rating plate.
Possible cause
Mains plug is
plugged in or is loose
Fuse has blown or is
defective
Socket is defective
Temperature is set too
cold or the appliance
runs at "6" setting.
Temperature is
properly adjusted.
Door was open for an
extended period.
A large quantity of warm
food was placed in the
appliance within the last
24 hours.
The appliance is near a
heat source.
Door seal is not air-tight.
Appliance is not level.
The appliance
touching the wall
other objects.
A component, e.g. a
pipe, in the side of the
appliance is
touching another part of
the appliance or the
wall.
63
Solution
not Insert mains plug.
Check fuse,
necessary.
Mains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator
to a warmer setting temporarily.
not Please look in the initial
Temperature Setting section.
Open the door only as long as
necessary.
Turn the temperature regulation
to a colder setting temporarily.
Please look in the installation
location section.
Carefully warm
sections of the door seal with a
hair dryer (on a cool setting). At
the same
time shape the warmed door
seal by hand such that it sits
correctly.
Check the appliance and level it
by some articles.
is Move the appliance slightly.
or
If necessary, carefully bend the
component out of the way.
replace if
the leaking