Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING AND REMOVING THE EDGE
GUIDE ASSEMBLY (FIG. 7, 8, 9, AND 10)
The edge guide assembly is used to trim or cut
a straight edge.
To install the edge guide assembly
1. Turn the lock lever of the edge guide
assembly to the left as far as it will go.
2. Insert the "hook" of the edge guide assembly
into the edge guide slot (Fig. 7).
3. Turn the lock lever to the right as far as it will
go to secure the edge guide assembly to the
base (Fig. 8).
NOTE: If the connection of edge guide
assembly is loose, perform the following steps
(Fig. 9):
a. With the lock lever in the right-most
position, pull the lock lever away from the
hook until the lever can freely turn left or right.
b. With the spring compressed, rotate the
lock lever to the left. You shouldn't feel any
resistance!
c. Release the lock lever to let it spring back
and engage with the tightening mechanism.
d. Turn the lock lever to the right until the
edge guide assembly is securely attached to
the base.
Fig. 9
a
Fig. 7
Fig. 8
b
-13-
Hook
Lock Lever
Edge Guide
Assembly
c
d
Publicidad
