Publicidad
Idiomas disponibles
Idiomas disponibles
To remove the edge guide assembly
1. Turn the lock lever all the way to the left.
2. Remove the edge guide assembly from the
slot.
NOTE: If the edge guide assembly could
not be removed easily, perform the following
steps (Fig. 10):
a. With the lock lever in the left-most position,
pull the lock lever away from the hook until
the lever can freely turn left or right.
Fig. 10
a
INSTALLING AND REMOVING THE DUST
EXTRACTION HOOD (FIG. 11 AND 12)
The dust extraction hood attaches to the
router base for dust free routing when used in
combination with a suitable vacuum cleaner/
dust extractor. The dust extraction hood allows
connection of a 1-1/4" (32 mm) vacuum hose or
adaptor.
To install the dust extraction hood
1. Insert the peg on the left side of the dust
extraction hood into the slot on the left side of
the base (Fig. 11).
2. Snap the right side of the hood with the screw
knob onto the right side of the base.
3. Manually thread and tighten the screw knob
into a threaded opening on the right side of
the base (Fig. 12).
To remove the dust extraction hood
1. Fully unscrew the screw knob from the base.
2. Release the peg of the hood from the slot on
the left side of the base.
3. Pull the dust extraction hood away from the
base.
b. With the spring compressed, rotate the
lock lever to the right. You shouldn't feel any
resistance!
c. Release the lock lever to let it spring back
and engage with the tightening mechanism.
d. Turn the lock lever to the left until the edge
guide assembly can be removed from the
edge guide slot.
b
Fig. 11
Fig. 12
-14-
c
Slot
d
Peg
Screw Knob
Publicidad
