Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING
allow a fluid to flow inside them. Corrosive or conductive fluids, such as seawater, certain
industrial chemicals, and bleach or bleach-containing products, etc. can cause a short circuit.
WARNING
result in serious personal injury.
This TRIM Router must be used only with the battery packs and chargers listed below:
2.5Ah
3.5Ah
5.0Ah
FX0111 FX0321 FX0121 FX0331 FX0221 FX0341 FX0231
NOTICE: Please refer to the battery pack and charger manuals for detailed operating
information.
SOFT START FEATURE
The soft-start feature minimizes torque twist,
which is customary in router motors, by limiting
the speed at which the motor starts. This
increases the life of the motor.
ON/OFF SWITCH (FIG. 19)
To start the router, depress and release the
on/off switch once.
To stop the router, depress and release the on/
off switch again.
Always hold the tool and cutter bit away from
the workpiece when turning on the switch. Only
allow the tool and cutter bit to come into contact
with the workpiece after it has reached full
speed.
LED LIGHTS (FIG. 19)
The tool is equipped with 2 built-in LED
lights located around the collet. They provide
additional light on the surface of the workpiece
for operation in lower-light areas.
The LED light will automatically turn on when
starting the tool, and will turn off approximately
10 seconds after the tool is stopped.
NOTE:
The LED lights will flash to signal that the
•
spindle lock is engaged when the On/Off
switch is pressed. Release the spindle lock
and start the tool again.
OPERATION INSTRUCTIONS
To reduce the risk of fire, personal injury, and product damage due to a
short circuit, never immerse your tool, battery pack or charger in fluid or
If any parts are damaged or missing, do not operate this product until the
parts are replaced. Use of this product with damaged or missing parts could
Battery Pack
6Ah
8.0Ah
10Ah
12Ah
FLEX
FX0411
Fig. 19
On/Off
Switch
The LED lights will rapidly flash when the tool
•
and/or battery pack becomes overloaded or
too hot, and the internal sensors will turn the
tool off. Rest the tool for a while or place the
tool and battery pack separately under air flow
to cool them.
The LED lights will flash more slowly to
•
indicate that the battery is at low-battery
capacity. Recharge the battery pack.
-19-
Charger
FLEX
FLEX
FLEX
FX0421
FX0431
FX0451
LED Lights
Publicidad
