Publicidad
Idiomas disponibles
Idiomas disponibles
2
Making Measurements
Changing the default temperature unit
Follow the steps below to change the temperature unit between Celsius (°C) or
Fahrenheit (°F).
1 Press and hold
2 Press
3 Press
4 Cycle the clamp meter's power to exit the temperature unit selection menu.
Always set the temperature unit display per the official requirements and in
CAUTION
compliance with the national laws of your region.
The bead-type thermocouple probe is suitable for measuring temperatures from
NOTE
–40 °C to 204 °C (399 °F) in PTFE-compatible environments. Do not immerse this
thermocouple probe in any liquid. For best results, use a thermocouple probe
designed for each specific application — an immersion probe for liquid or gel,
and an air probe for air measurement.
Observe the following measurement techniques:
– Clean the surface to be measured, and ensure that the probe is securely
– When measuring above ambient temperatures, move the thermocouple
– When measuring below ambient temperatures, move the thermocouple
– Place the clamp meter in the operating environment for at least 1 hour as the
60
and
temperature unit selection menu.
to make changes to the temperature unit.
Press
or
to change the temperature unit (°C or °F).
to save the changes.
touching the surface. Remember to disable the applied power.
along the surface until you get the highest temperature reading.
along the surface until you get the lowest temperature reading.
clamp meter is using a non-compensation transfer adapter with miniature
thermal probe.
while powering on the clamp meter to enter the
Keysight U1190A Series User's Guide
Publicidad
