Cameo F2 FC IP Manual De Usuario página 13

ATTENTION: In order to provide protection from spraying water, in accordance with
protection class IP65, special IP65-rated XLR connectors must be used correctly with the
DMX input and output sockets, or they must be closed using the rubber sealing caps.
When connected correctly, or when sealed correctly with the rubber sealing caps, the
POWER IN and POWER OUT sockets are protected from spraying water, as in accordance
with IP65.
OPERATION
NOTES
• As soon as the spotlight is correctly connected to the power supply, the following will be
displayed in succession: „Welcome to Cameo", the model name and the software version. After
this process, the lamp is ready for operation and starts in the previously enabled mode.
• If one of the DMX modes or slave mode is enabled and there is no control signal at the DMX
input, the characters in the display will start to flash.
• If no input is made within approx. 1 minute, the currently activated operating mode is automati-
cally shown in the display (main display).
DISPLAY MAIN DISPLAY DMX MODE
The main display in DMX mode shows the currently set DMX start address, DMX mode and other
information (see illustration).
currently activated operating mode
DMX start address and DMX mode
Press encoder =
Selection of the operating mode
(Mode)
= DMX signal is present
 
4CH Direct
= no DMX signal
Fan mode
Press encoder =
Open main menu (Menu)
13