Cameo F2 FC IP Manual De Usuario página 22

Colour = Colour calibration
Calibrat-
ion
Autolock = Automatic locking of
the controls
Fan = Fan setting
Factory = Reset to factory
Reset settings (without
resetting the User
Colors and Loops)
UC/Loops = Resetting the User
Reset Colors and the Loops
to Factory Default
22
RAW - Off R, G, B and W with maximum value 255
RAW - Adjust Press middle encoder = switch between
(individual, R+G and B+W (colour)
cross-mode Turn middle encoder = set value of R or
adjustment of B
R, G, B, and
Press right encoder = one level higher in
W with values
the menu structure (ESC)
from 000 to
Turn right encoder = set value of G or W
255 each)
Press left encoder = confirm and save
settings
Calibrated Factory calibration of R, G, B and W
(across all modes). Select this setting for
the correct display of the colour tones
and presets in the standalone modes
CCT and Gel , as well as when controlling
CCT and the presets Gel via DMX.
Smart Calibrat- Merging Factory (Calibrated) and RAW
ion Calibration
On Automatic locking of the controls after
approximately 30 seconds of inactivity.
Display after operating attempt:
"Locked!"
Unlocking: Press the middle and right
encoder simultaneously for approx. 3
seconds
Off Automatic locking of the controls is
disabled
Car Automatic fan control
Off Deactivated fan with greatly reduced
brightness
Constant Low Constantly low fan speed with reduced
brightness, if necessary
Constant Constant average fan speed with
Medium reduced brightness, if necessary
Constant High Constant high fan speed
Reset Now? Reset to factory settings:
confirm with ENTER, cancel with ESC
Reset User Reset to factory settings:
Colors/Loops confirm with ENTER, cancel with ESC