Publicidad
Idiomas disponibles
Idiomas disponibles
6 Assembling the exterior switch cabinet (optional)
6.4
Assembling the plastic exterior cabinet L
The plastic column intended for outdoor installation should be sunk into the ground up to the mark on the
front of the cabinet. A ditch of a sufficient depth should be dug. In order to avoid overheating in summer, a
site must be chosen in which the column is not continuously exposed to direct sunlight.
To reduce earth moisture, fill the empty space inside the base with appropriate base filling granulate (art.
no. 107607). The filling material can remain in the cabinet base permanently and does not need to be
changed.
A cabinet open to the surrounding ground may result in corrosion damage
on the electrical components in the event of high levels of ground moisture!
A ditch with the following measurements should be
prepared at the planned site:
Exterior column
Length approx
360 mm
Width approx
360 mm
Depth approx 600–
640 mm
The empty pipe and the air hoses must be routed
into the prepared ditch.
The foundation base for the L exterior cabinet must
be assembled according to the accompanying as-
sembly instructions.
The cabinet must then be inserted vertically into the
ditch to a depth of approx. 60–64 cm. Make sure
that the cabinet is stable and secure and is installed
vertically in the ditch.
43 / 144
Exterior cabinet
Length approx
585 mm
Width about 315 mm
Depth approx 600–
640 mm
Publicidad
