EGAmaster 79902 Manual De Instrucciones página 23

Use acid and resin-free lubricating oil, like SAE 5W - SAE 10W, for proper functioning of the pneumatic impact
wrench.
Attention! Do not use viscous oil.
Use an antifreeze lubricant, e.g.:
. "BP-Energol AX 10",
. "Kilfrost" ,
. or "Kompranol N74" in winter and if the compressed air is very moist.
The supplied compressed air has to be free of:
. Foreign particles,
. humidity.
Pay attention that all hoses:
. Have a cross section being large enough,
. do not have any restrictions or kinks,
. are designed for a minimum operating pressure of 6 bar,
. are replaced regularly at preventative maintenance,
. have an oil resistant inner surface and an abrasion-resistant outer surface,
. are proved and specified to be non-conductive when being used next to electric conductors.
Always use hoses, lubricating oil and antifreeze lubricants, which meet the local safety requirements for use
in areas exposed to explosion hazards.
Connecting the air supply to the pneumatic impact wrench
Remove the locking cap from the air connection (see fig. 2). Connect the pneumatic hose (not contained in the
scope of delivery). For underwater applications, additionally screw-on an exhaust hose (not contained in the scope
of delivery). Instead of the exhaust hose, an exhaust nipple can be screwed in optionally.
When connecting the machine, pay attention that the valve trigger 1 (see fig. 3) is not actuated.
Air inlet
Fig. 2
STARTUP
Fig.3
Exhaust
23