Basic Safety Instructions - EGAmaster 79902 Manual De Instrucciones

Pay attention that the socket is firmly seated.
Only use sockets with suitable shank (see "Technical Specification").
Remove the socket
Pull the socket from the square.
Sockets being stuck can be loosened by slight beats with a rubber hammer.
Change the sockets
When inserting a socket, pay attention that it is properly seated on the square drive 6. If the socket is not firmly
fixed to the square drive, it can unscrew.
Before underwater operation
Ensure that:
. The exhaust hose is connected and fixed at the supply hose,
. The exhaust hose is long enough to protrude above the water. In case of a short exhaust hose (in the
water) a reverse valve is used, so that water cannot get into the machine when plunging with the
machine,
. The machine is tested for leakage and for the functioning of all parts (drilling, blowing, valves, etc.).
Notice: Keep in mind that 10 meter water depth corresponds to 1 bar.
When working in greater depths match the diameter of the supply and exhaust hose appropriately.
After underwater operation
. Clean and dry the machine with compressed air.
. Spray all moving parts with multi-oil-spray
Read operation instructions/safety instructions!
Before working on or with the tool, read the safety instructions and follow the instructions during operation.
Do not modify the machine or the machine tools and accessories after receipt. Any constructive changes or
modifications need the manufacturer`s acceptance and have to be in compliance with the safety instructions. Use
the machine only for its determination. Consider the technical data of the equipment and the ambient temperatures.
Pay attention to labels, restrictions of use and special instruction notes on the machine tools and the machine itself.
Check regularly that the type plate and symbols on the machine are legible. If necessary, contact the manufacturer
to replace them. Only operators with technical knowledge, trained by authorized responsible technical personnel,
may install, adjust, operate, transport and store the machine.
Generally, the employer is responsible for the faultless condition/operation of the machine and the adherence to
the safety regulations. The machine is designed and manufactured according to the technical safety regulations.
However, using it, there is still a risk of accidents to the operator or third parties or damage to the machine or
other objects. All current regulations and specifications, which apply to the site of operation in regards to accident
prevention, installation of electrical and mechanical systems as well as radio interference must be considered.
IMPORTANT - The employer must make sure that...
• risk assessment is carried out for the specific risks, which can occur due to any operation of the machine,
• the function of the safety equipment is regularly checked,
UNDERWATER USE
.

BASIC SAFETY INSTRUCTIONS

EMPLOYER'S OBLIGATIONS
25