YATO YT-83082 Manual De Instrucciones página 14

or as a signal lamp. To activate the LED, press and hold the button marked with the symbol of a fl ashlight for about 3
seconds. A single press of the button will change the lighting mode in the following sequence: continuous light, fl ashing,
SOS signal encoded in Morse code.
To de-activate the fl ashlight, press and hold the button marked with the fl ashlight symbol for about 3 seconds.
Product maintenance
The product does not require any special maintenance. Clean the product casing with a soft, dry cloth. Never immerse
the product in water or in any other liquid. Protect the product sockets against contamination. If the socket is dirty, try
to clean it by blowing a jet of compressed air stream into it, at a pressure not exceeding 0.3 MPa. Do not use any hard
objects to clean the sockets, as this can damage the socket or cause a short circuit.
Storage and transport of the product
The product should be stored indoors, in shaded places, where the temperature does not exceed the range specifi ed
in the table and the relative humidity is below 90%.
Transport the product taking into account the recommendations provided in the section: "Transport of batteries".
TECHNICAL DATA
Parameter
Catalogue No.
Rated start-up voltage
Rated start-up current
Peak start-up current
Start-up time
Interval (break time)
USB port output voltage
Max. output current of USB socket
DC port output voltage
Max. output current of DC socket
Input voltage
Input current
Rated battery voltage
Battery capacity
Battery energy
Battery type
Operating temperature
Storage temperature
Charging time
Weight
Charger
Rated input voltage
Rated frequency
Rated input current
Rated output voltage
Rated output current
14
O R I G I N A L
EN
Unit
[V DC]
[A]
[A]
[s]
[s]
[V DC]
[A]
[V DC]
[A]
[V DC]
[A]
[V DC]
[Ah]
[Wh]
[ C]
O
[ C]
O
[h]
[kg]
[V~]
[Hz]
[A]
[V DC]
[A]
I N S T R U C T I O N S
Value
YT-83082
12
300
500
2
30
5
2.4
19 /12
3.5 / -
15
1
3.7
12
44.4
Li-Ion
0 – 35
0 – 50
4
0.4
100 – 240
50/60
0.3
15
1