Integrated Cleaning Programme - melitta CaffeO SOLO Manual De Instrucciones

9.3

Integrated cleaning programme

The integrated cleaning programme removes residues, including coffee oil residues,
that cannot be eliminated by hand. It takes a total of approximately 15 minutes. The
cleaning symbol flashes during the entire process.
Prerequisite: The appliance must be switched off (see „Switching on and off"
on page 49).
Caution!
– Run the integrated cleaning programme every 2 months or after
approximately 200 brewed cups of coffee; at the latest, however, run the
programme when the symbol for cleaning
– Only use Melitta
cleaning tabs are specifically designed for the Melitta
The use of other cleaning agents can damage the appliance.
Run the integrated cleaning programme as follows:
1 Open up the flap of the water tank (Fig. A, no. 6) and pull the water tank
up and out of the appliance. Fill the water tank to the max. mark with
fresh tap water and reinsert it.
2 Simultaneously press both the button for one-cup dispensing
the ON/OFF button
→ The symbol for cleaning
The drip tray symbol
3 Empty the drip tray and coffee grounds container.
4 Reinsert the drip tray without the coffee grounds container and place
the coffee grounds container under the outlet.
Phase 1
During Phase 1, the one bean symbol
→ First, two automatic rinsing processes are carried out. The standby symbol
will then be illuminated.
5 Reach into the recess on the right side of the appliance (Fig. A, no. 11)
and pull off the cover to the right.
62 62
cleaning tabs for fully automatic coffee makers. These
®
for about 3 seconds.
flashes.
illuminates.
is shown on the display.
lights up on the display.
CAFFEO SOLO
® ®
.
®
and