Publicidad
Idiomas disponibles
Idiomas disponibles
b) Make sure the spray hose is free of debris, carbon deposits, etc.
c)
Turn on the unit by setting the ON/OFF switch to the "I" position
and wait until the unit generates maximum pressure (gauge
reading reaches maximum for this product).
d) Once the compressor motor shuts off, i.e. maximum pressure is
reached, painting can begin, however perform a small test spray
first is recommended - the spray should be evenly distributed
along its entire length - see the picture below:
3.3.5
Painting Tips
The key to a good result is an even layer of material over the entire
painted surface.
a) The gun should be held parallel to the surface - work with your
whole hand/arm, not just bend your wrist.
Publicidad
