Publicidad
Idiomas disponibles
Idiomas disponibles
m) Put a new ring seal on the intake valve set and lubricate it with "TSL"
n) Align the piston to the yoke taking care not to damage the piston.
o) Lubricate the piston and the area around the yoke with grease to
p) Install the locking pin to connect the yoke to the piston - it may be
q) Screw in the yoke screw and washer to secure the locking pin.
r)
s)
t)
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal
household waste but should be taken to a collection point for the recycling of
electrical and electronic equipment. This is indicated by the symbol on the
product, operating instructions or packaging. The materials used in this unit are
recyclable according to their marking. You will be making an important
contribution to protecting our environment by reusing, recycling or otherwise
disposing of used units.
Your local administration will provide you with information about the
appropriate disposal point for used units.
TROUBLESHOOTING
Problem
A. The unit does not start.
oil, then screw it in from the bottom (inlet) of the housing. This should
set the seal in the correct position.
extend their life. Apply grease to the holes in the yoke where the
plunger is inserted.
necessary to move the piston up or down to do this.
Set the unit back on its feet and add a few drops of "TSL" oil between
the top nut and the piston.
Replace the front casing and tighten it with the 4 screws.
Replace the inlet valve and attach the suction hose kit.
Possible cause
a) The unit is not
b) The ON/OFF switch is
c) No power at the
d) Power cord or
e) Fuse blown in the
connected to the
power supply.
in the "O" (off)
position.
outlet.
extension cord
damaged.
machine.
Action
a) Connect the unit to
the power supply.
b) Set the ON/OFF
switch to the on ("I")
position.
c) Check power at outlet
and/or building
wiring, etc.
d) Replace/repair the
power cord or the
extension cord.
Publicidad
