Publicidad
Idiomas disponibles
Idiomas disponibles
3.
Balancing environment
This function makes it possible to select the
working environment required based on the
type of wheel to be balanced:
- AUTO for vehicle wheels with a central hole
- MOTO for motorcycle wheels
- FLANGE for vehicle wheels without a central
hole
In the FLANGE and MOTO environment, the
automatic clamping system pedal is disabled
as the wheel is centred using the respective
accessories.
Using the wheel balancer in FLANGE mode
remains the same as the AUTO environment,
in the MOTO environment the methods
change as described in the "Motorcycle wheel
balancing" section.
4.
Enables/disables the unbalance display
mode (gx1 or gx5).
-
Select this button to display the unbalance
mass in grams:
to the nearest gram or 1/10 of an
ounce if the unit of measurement has been
set to ounces;
or
to the nearest 5 grams or 1/4 of an
ounce if the unit of measurement has been
set to ounces.
This function is not enabled in the ALU1 and
ALU2 programmes (see the "Shift Planes pro-
gramme" section).
5.
print menu:
-
Select this button to access the print menu
for the programme that is running.
The following is possible in the menu:
-
Fill out the empty fields in the report by
pressing the text Entry button
-
Start the print process with the Print button
.
54
FEEDBACK WINDOW
The feedback window, as shown in the figure
below, displays the following information:
-
Name of operator (see the "Customisation"
section).
-
Wheel dimensions during the last spin: white
if measured automatically; or yellow if set
manually.
or grey if calculated statistically and NOT ac-
quired automatically by the machine.
CAUTION
This data (in grey) may NOT correspond with
the wheel's rated dimensions. This display
does NOT indicate a machine error (as the
dimensions are calculated statistically and
NOT automatically measured) or an error in
the unbalance display.
- The status of the clamping brake (enabled or
not enabled)
- Enabling of the WM programme
- The selected balancing environment (ref. "Con-
figuration Programmes" section)
SHUTTING DOWN
This function starts the shutdown process which
protects the Windows operating system installed
on the mother board and depowers the machine.
Proceed as follows:
.
-
Press the Enter button
-
Wait for the PC to be turned off completely
as confirmed by an intermittent beep.
-
Press the switch on the back of the body (C,
Fig. 5).
EM9980 TouchlessLine - Operator's manual
.
Publicidad
