Descargar Imprimir esta página

Corghi EM9980 TouchlessLine Manual De Uso página 65

Ocultar thumbs Ver también para EM9980 TouchlessLine:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

-
press the
button on the monitor to
confirm and switch to the width value entry
phase;
-
Change the displayed value to the value
measured using the manual calliper (Fig. 21).
-
press the
button on the monitor to
confirm and switch to the diameter value entry
phase;
-
Change the value of the diameter displayed
by entering the value indicated on the tyre
using the keypad.
-
Press the Exit
the manual data setting.
Note: When dimensions are set manually, clip or
adhesive weights must be applied manually in
the 12 o'clock position.
3. Suite WHEEL DIAGNOSIS PROGRAMME
3.1. Radial and lateral runout measurement
This function is used to determine the causes of
disturbance (vibration) generated by geometric
deformation of the rim and/or tyre, which may
still persist even after a thorough balancing
procedure.The machine indicates that the pro-
cedure needs to be performed by displaying the
EM9980 TouchlessLine - Operator's manual
21
button to terminate
following war-ning light
can decide to perform the procedure whenever
considered necessary.
To do this, perform a spin.
If a wheel assembly is mounted, the following
icons are displayed on the screen at the end of
the spin indicating:
-
the radial run-out of the wheel (1st harmonic);
-
the radial run-out of the wheel peak-to-peak;
-
the lateral run-out of the wheel (1st harmonic);
-
the lateral run-out of the wheel peak-to-peak;
-
the radial run-out of the rim (1st harmonic);
-
the radial run-out of the rim peak-to-peak;
-
the radial run-out of the tyre (1st harmonic);
. The operator
UK
65

Publicidad

loading