Cramer 82T20 Manual De Instrucciones página 5

3.3 ATTACH THE AUXILIARY
HANDLE
Figure 3.
1. Remove the screws from the handle with the supplied
torx wrench.
2. Attach the auxiliary handle and lower clamp on the shaft.
3. Set the auxiliary handle in the comfortable position.
4. Tighten the screws.
3.4 INSTALL THE BATTERY PACK
Figure 4.
WARNING
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, understand, and follow the instructions in the
battery and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.5 REMOVE THE BATTERY PACK
Figure 4.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4 OPERATION
IMPORTANT
Before you operate the machine, read and understand the
safety regulations and the operation instructions.
WARNING
Be careful when you operate the machine.
4.1 START THE MACHINE
Figure 5.
1. Push the lock-out lever and pull the trigger.
2. Push the speed switch to the desired operating speed.
Push the speed switch to position 1 for low speed or
position 2 for high speed.
4.2 STOP THE MACHINE
Figure 5.
English
1. Release the trigger to stop the machine.
4.3 OPERATION TIPS
Figure 6.
Keep clearance between the body and the machine.
Do not operate the machine without guard in place.
Follow these tips when you use the machine:
• Keep the machine connected to the correctly worn
harness.
• Keep a firm hold with two hands on the machine while
you operate the machine.
• Cut tall grass from the top down.
If grass winds around the trimmer head:
• First, remove the battery pack.
• Then, remove the grass.
4.4 CUTTING TIPS
Figure 7.
• Tilt the machine towards the area to be cut. Use the tip of
the cutting line to cut grass.
• Move the machine from right to left to prevent thrown
debris toward the operator.
• Do not cut in dangerous areas.
• Do not force the trimmer head into uncut grass.
• Wire and picket fences cause cutting line wear and
breakage. Stone and brick walls, curbs, and wood can
wear the cutting line quickly.
4.5 LINE CUT-OFF BLADE
Figure 7.
This trimmer is equipped with a line cut-off blade on the
guard. The line cut off blade continuously trims the line to
ensure a consistent and efficient cut diameter. Advance line
whenever you hear the engine running faster than normal, or
when trimming efficiency diminishes. This will maintain best
performance and keep the line long enough to advance
properly.
4.6 ADJUST THE LENGTH OF THE
CUTTING LINE
Figure 8.
While you operate the machine, the cutting line gets worn and
shorter. You can adjust the length of the cutting line.
1. Hit the trimmer head against the ground while you
operate the machine.
5
WARNING
WARNING
EN