Wiesenfield WIE-CLI-100 Manual De Instrucciones página 35

TROUBLESHOOTING
Possible unwanted effects of the unit are presented in the table below. If a fault
occurs that is not listed, contact an authorized service center.
Problem
Cutting head overheats
Cutting head does not cut
No feed of blades over
entire running surface
No blade feed
Spontaneous loosening of
the tension nut
CUTTING HEAD
Possible cause
Blade tension is too
high
No oiling of the
crankshaft
No lubrication in the
sliding sleeve
Bearings worn out
Comb plate
incorrectly mounted
Worn blades and
comb plate
Defective tensioning
link
Worn crank spindle
and/or crank roll
and/or turn fork
Bearings worn out
Defective gears
Defective reduction
gearing of motor
section
Crank spindle bent or
broken
Crankshaft missing
The tension lock
spring is missing
Action
Reduce blade tension and
sharpen cutting elements if
necessary
Oil the crankshaft
Oil the slide bushing
Replace the bearings with new
ones
Adjust comb plate
Sharpen the blades and comb
plate
Replace the tensioning link
Replace worn crank spindle
and/or crank roll and/or turn fork
Replace the bearings
Replace the gears
Replace the reduction gear
Replace the crank spindle
Replace the crankshaft
Replace the tension lock spring
and adjust so that the adjustment
can be carried out freely