Publicidad
Idiomas disponibles
Idiomas disponibles
Daily Use
Troubleshooting
Caution! Before troubleshooting, disconnect the power supply. 4nly a qualified electrician of
competent person must do the troubleshooting that is not in this manual.
Important! There are some sounds during normal use -compressor, refrigerant circulation..
Problem
:ppliance does not
work
:ppliance freezes
too much
The food is not frozen
enough.
/eavy build"up of
frost on the door
seal.
;nusual noises
)f the malfunction shows again, contact the Service Center.
These data are necessary to help you quickly and correctly. (rite the necessary data here, refer to the
rating plate.
Possible cause
6ains plug is not plugged in
or is loose
Fuse has blown or is defective
Socket is defective
Temperature is set too cold
or the appliance runs at MAX
setting.
Temperature is not properly
ad8usted.
Door was open for an extended
period.
: large quantity of warm food
was placed in the appliance
within the last $% hours.
The appliance is near a heat
source.
Door seal is not air"tight.
:ppliance is not level.
The appliance is touching the
wall or other ob8ects.
: component, e.g. a pipe, on
the rear of the appliance is
touching another part of the
appliance or the wall.
18
Solution
)nsert mains plug.
Check fuse, replace if necessary.
6ains malfunctions are to be
corrected by an electrician.
Turn the temperature regulator to a
warmer setting temporarily.
Please look in the initial Temperature
Setting section.
4pen the door only as long as
necessary.
Turn the temperature regulation to
a colder setting temporarily.
Please look in the installation
location section.
Carefully warm the leaking sections of
the door seal with a hair dryer -on a cool
setting.. :t the same time shape the
warmed door seal by hand such that it
sits correctly.
9e"ad8ust the feet.
6ove the appliance slightly.
)f necessary, carefully bend the
component out of the way.
Publicidad
