Publicidad
Idiomas disponibles
Idiomas disponibles
2.4. Safe use of the product
a)
Do not overload the product. Use tools that are suitable for the application. A
correctly selected product ensures better and safer performance of the work
it is intended for.
b)
Unplug the appliance from the mains before adjustment, cleaning or
maintenance. This safety precaution reduces the risk of accidental operation.
c)
Keep unused appliances out of the reach of children and anyone unfamiliar
with the appliance or this manual. Appliances are dangerous in the hands of
inexperienced users.
d)
Keep the product in good working order. Before each use, check for generally
evident damage and damage to any of the moving parts (inspect for cracks in
parts and components or any other condition that may affect the safe
operation of the product). If damaged, have the product repaired before use.
e)
Keep the product out of the reach of children.
f)
The product shall be repaired and maintained by qualified personnel using
original spare parts only. This will ensure safe operation of the product.
g)
To ensure the designed operational integrity of the product, do not remove
the factory-installed covers or loosen any bolts.
h)
Clean the appliance regularly to prevent permanent deposits of dirt.
i)
Always make sure that the nozzle is properly installed in the appliance and the
hose is properly attached and free of damage before use.
j)
The appliance is not a toy. Cleaning and maintenance shall not be performed
by children without adult supervision.
k)
Do not start the appliance when it is empty.
l)
Never attempt to tamper with the product to change its parameters or
structure.
m) Keep the appliance away from sources of fire and heat.
n)
Do not overload the product.
o)
Install the pump as close to the tank served by it as possible.
p)
The pump must never run dry.
q)
Always install a stop valve between the pump and the tank.
r)
For the suction line, use a 1-1/2" I.D. hose (which is non-coilable and rated for
vacuum). Use stainless steel band clips for all connections.
s)
All lines shall be smooth and free of kinks. Air leak into the suction side may
cause the pump to fail.
t)
For the discharge line, use a 1" or larger I.D. hose. Connect it to the outboard
through-fitting in the hull located above the maximum point of heel-in and
above the water line. If the system features a vent loop, it shall have the air
bleed located at least 10" above the maximum point of in-heel and above the
water line.
u)
Connect the pump to a separate power line from the power source.
Publicidad
