Zanussi ZDLN6531 Manual De Instrucciones página 20

Problem and alarm code
You cannot activate the appli-
ance.
The programme does not start.
The appliance does not fill with
water.
The display shows i10 or i11.
The appliance does not drain
the water.
The display shows i20.
The anti-flood device is on.
The display shows i30.
Malfunction of the water level
detection sensor.
The display shows i41 - i44.
Malfunction of the wash pump
or the drain pump.
The display shows i51 - i59 or
i5A - i5F.
The temperature of the water
inside the appliance is too high
or malfunction of the tempera-
ture sensor occurred.
The display shows i61 or i69.
Technical malfunction of the
appliance.
The display shows iC0 or iC3.
The level of water inside the
appliance is too high.
The display shows iF1.
The appliance stops and starts
more times during operation.
The programme lasts too long.
20
Possible cause and solution
• Make sure that the mains plug is connected to the mains sock-
et.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the end of
the countdown.
• The appliance recharges the resin inside the water softener.
The duration of the procedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clogged.
• Make sure that the drain hose has no kinks or bends.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in the user
manual.
• Make sure that the filters are clean.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the temperature of the inlet water does not ex-
ceed 60°C.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right height
above the floor. Refer to the installation instructions.
• It is normal. It provides optimal cleaning results and energy sav-
ings.
• If the delay start option is set, cancel the delay setting or wait
for the end of the countdown.
• Activating options can increase the programme duration.