Zanussi ZDLN6531 Manual De Instrucciones página 21

Problem and alarm code
The displayed programme du-
ration is different than the du-
ration in the consumption val-
ues table.
The remaining time in the dis-
play increases and skips nearly
to the end of the programme
duration.
Small leak from the appliance
door.
The appliance door is difficult
to close.
The appliance door opens dur-
ing the wash cycle.
Rattling or knocking sounds
from the inside of the appli-
ance.
The appliance trips the circuit-
beaker.
Once you have checked the appliance, deactivate
and activate the appliance. If the problem occurs
again, contact an Authorised Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
WARNING! We do not recommend
using the appliance until the problem
has been completely fixed. Unplug the
appliance and do not plug it in again
until you are certain that it operates
correctly.
THE PRODUCT NUMBER CODE (PNC)
If you contact an Authorised Service Centre, you
need to provide the product number code of your
appliance.
Possible cause and solution
• The pressure and the temperature of the water, the variations of
the mains supply, the options, the quantity of dishes and the
degree of soil can change the programme duration.
• This is not a defect. The appliance is working correctly.
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• The appliance door is not centred on the tub. Adjust the rear
foot (if applicable).
• The appliance is not levelled. Loosen or tighten the adjustable
feet (if applicable).
• Parts of the tableware are protruding from the baskets.
• The AirDry function is activated. You can deactivate the func-
tion. Refer to "Basic settings".
• The tableware is not properly arranged in the baskets. Refer to
basket loading leaflet.
• Make sure that the spray arms can rotate freely.
• The amperage is insufficient to supply simultaneously all the ap-
pliances in use. Check the socket amperage and the capacity
of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised
Service Centre.
The PNC can be found on the rating plate on the
appliance door. You can also check the PNC on the
control panel.
Before checking the PNC, make sure the appliance
is in the programme selection.
1. Press and hold simultaneously Glass Care
and AUTO for about 3 seconds.
The display shows the PNC of your appliance.
2. To exit the PNC presentation, press and hold
simultaneously Glass Care and AUTO for
about 3 seconds.
The appliance returns to the programme selection.
21