OHAUS Adventurer AX124 Manual Del Usuario página 6

EN-4
3. INSTALLATION
3.1 Selecting the location
The location must be sturdy, flat and level. Avoid locations with excessive air
current, vibrations, heat sources or rapid temperature changes. Allow sufficient
space around the instrument.
3.2 Connecting Power
Connect the AC adapter power cord to the instrument's power input connector, and
then connect the AC plug to a suitable electrical outlet.
Attention: Only use an AC adapter specified by OHAUS.
Attention: For optimal weighing performance, allow the balance to warm
up for 60 minutes prior to use.
3.3 Connecting the Interface
Use the built-in RS-232 Port to connect either to a computer or a
printer with a standard (straight-through) serial cable.
Or connect using the scale's USB port.
Interface connections on the rear of the balance:
USB connection on the front of the balance:
.
USB1
USB1: Used to connect to PC only
USB2: Used to connect a USB flash driver only
RS232: Used to connect to PC or Printer
RS232