TensCare FORM Instrucciones De Uso página 10

Note: The stimulator must be
connected to the electrode in the
correct orientation. If you feel magnetic
resistance, rotate the stimulator 180° and try
connecting again.
Warning: Ensure the stimulator is
switched off before connecting to, or
removing from the electrodes.
We recommend competing a Form
recovery session in a comfortable resting
position, ideally seated or lying down.
Completing A Session
1) Press the control button for one second to
switch the stimulator on.
The smart electrode will now automatically
configure the programme output settings.
2) Increase the intensity by rotating the
stimulator dial in a clockwise direction.
10
There are 45 levels of intensity. On first use,
we recommend increasing the intensity
slowly. The aim is to produce small, visible
muscle contractions.
Note: The intensity cannot be
increased until it is connected to the
electrode.
3) Once the intensity has been selected,
after 5 seconds the display will indicate the
20 minute remaining session time.
4) It may be necessary to increase the
intensity during a session as your body
becomes accustomed to the stimulation.
Note: If there is a connection error
during the session, the display will
flash 5 times, the session will pause, and the
intensity will revert to zero. This could be due
to either:
• The stimulator has been disconnected
from the electrode
• The electrode is not making a good
connection with the body
Ensure the stimulator and electrode are
connected and applied correctly to the
body. Once reconnected the stimulator will
remember the remaining treatment time.
The intensity will need to be increased.