TensCare FORM Instrucciones De Uso página 11

After A Session
At the end of the 20-minute session, the
stimulator will automatically switch off. We
recommend one Form recovery session
per each muscle group after exercise.
Complete a new session on the next
targeted muscle.
1. Disconnect the stimulator from the
electrode.
2. Remove the smart electrode and
attached hydrogel from the body, ensuring
the hydrogel remains applied to the rear of
the electrode.
3. Apply to the next targeted muscle.
4. Once you have completed all required
muscle groups, disconnect the stimulator
and remove the smart electrode as before.
5. Re-apply the clear plastic liner onto the
hydrogels and store the electrodes and the
stimulator in the travel case. Proper storage
between uses will help maximise the life of
the gel.
5. Charging Form
When the stimulator battery level reduces
below 20%, the display will start to pulse
slowly. Once it is less than 10% the display
will flash quickly.
Charge the stimulator using the provided
charging cradle and micro-USB cable.
As with the electrodes, the stimulator will
magnetically connect to the cradle. Ensure
the stimulator is in the correct orientation to
allow the magnets to attract.
The stimulator is fully charged once the
display shows a complete full circle.
Note: Battery should take 60 minutes
to charge. The battery life will last
approximately 22 hours in normal use at
50% intensity.
Ensure the stimulator is fully charged before
first use.
11