RIDGID BS1400 Manual Del Propietário página 17

Attaching Band Saw to Leg Set
1. From the loose parts bag find the fol-
lowing hardware:
4 M8 x 35 Hex Head Bolts
(approx. 1-3/8")
8 M8 Washers
4 M8 Lockwashers
4 M8 Nuts
2. From the loose parts find the following:
1 Support Plate
3. While one person continues to hold the
saw from tipping, the other person
should install mounting bolts.
4. Line up holes in saw body with holes in
stand.
5. Place support plate to the underside of
stand as shown.
6. Fasten saw body, stand, and support
plate together with four hex head bolts,
eight flat washers, four lockwashers,
and four hex nuts.
Adjusting Leveling Feet
WARNING: To reduce the risk of
injury from unexpected saw or
work movement, leveling feet
must be adjusted so that saw
does not rock.
To adjust leveling feet so the saw will
sit properly:
1. Move saw to desired location.
2. Raise or lower leveling foot by turning
the nuts clockwise or counterclock-
wise.
3. Tighten nuts to lock leveling foot in
place.
Bolt Hex Head
M8 x 1.25-35
Washer M8
Lockwasher M8
Bolt Hex Head
Washer
Lockwasher
Nut
Leg
Nut
Leveling
Foot
17
Support Plate
Nut Hex M8
Support Plate