RIDGID BS1400 Manual Del Propietário página 24

Alignments and Adjustments
Tilting the Table
WARNING: Unplug the machine
from the power source before
making any repair or adjustment.
Failure to comply may cause
serious injury.
1. Loosen two lock knobs.
2. Tilt table up to 45 degrees to the right
or up to 10° to the left.
3. Tighten two lock knobs.
NOTE: 90° table stop must be removed to
tilt table 10° to the left.
Adjusting 90° Table Stop
1. Disconnect machine from the power
source.
2. Loosen lock knobs and tilt table left
until it rests against table stop.
3. Use a square placed on the table and
against the blade, to see if the table is
90 degrees to the blade.
4. If an adjustment is necessary, loosen
lock knobs. Tilt table to the right, and
lock in place.
5. Loosen jam nut and turn table top left
or right to raise or lower the stop.
Tighten jam nut to hold table stop in
place.
6. Unlock table, tilt back onto table rest
and confirm table is 90 degrees with
the blade.
7. If necessary, adjust pointer to zero.
90° Table
Stop
Jam Nut
24
Lower
Rotating
Blade Guard
Table Pin
Table Insert