Fox FLOAT SL Manual Del Propietário página 8

REMOTE INSTALLATION
REAR SHOCKS
The remote can either be installed under the handlebar on the non-drive side, where a front shifter would
typically be placed, or installed above the handlebar on the drive side. The remote can be used with two
cables to control both the fork and shock simultaneously.
1. Route the cable housing from the remote lever to the rear shock cable stop and cut to length. Install
ferrules on both ends.
2. Set the remote lever to OPEN mode by pushing the release lever. Make sure that the cable head is
completely seated in the remote lever.
3. Use a short piece of housing with one ferrule between the in-line barrel adjuster and the remote
lever body.
4. With all cable housing fully seated and no slack in the system, lightly lubricate the inner cable and
thread it through the cable housing and the small hole in the blue remote pulley. Do not turn the
flush mounted set screw that attaches the blue remote pulley to the shock! The cable pinch bolt is
located in the protruding portion of the blue remote pulley.
5. While holding the cable tight, tighten the pinch bolt, cut off excess cable, and crimp the end.
ADDITIONAL TUNING OPTIONS
VOLUME SPACERS
Changing volume spacers in the shock is an internal adjustment that allows you to change the amount of
mid stroke and bottom out resistance.
If you have set your sag correctly and are using full travel (bottoming out) too easily, then you could
install a larger spacer to increase bottom out resistance.
If you have set your sag correctly and are not using full travel, then you could install a smaller spacer to
decrease bottom out resistance.
Installation procedure and tuning options are available online at: ridefox.com/ownersmanuals.
8