cecotec bolero DRESSCODE 8400 INVERTER Manual De Instrucciones página 46

ENGLISH
Loosen the clamp nut and four bolts.
Tighten the clamp nut.
Press slide bushing and insert inlet hose into connecting base.
Connection finished.
Connection between screw tap and inlet hose. Fig. 9.
Tap with threads and inlet hose.
Special tap for washing machine.
Connect the other end of inlet hose to the inlet valve at the backside of product and fasten the
pipe tightly clockwise. Fig. 10.
Drain hose
Note: Do not kink or protract the drain hose.
Position the drain hose properly, at 60-90 cm from the floor.
There are two ways to place the end of the drain hose:
In a drainpipe. It is recommended to use a vertical tube.
In a sink's drainpipe, over the trap.
Fig. 11
If the machine has drain hose support, it can also be installed on a sink or a tank, like the
following. Fig. 12.
Warning: When installing drain hose, fix it properly with a rope. If drain hose is too long, do not
force it into washing machine as it will cause abnormal noises.
4. OPERATION
Note:
Please make sure the appliance is properly installed before operating it.
Before washing the clothes for the first time, the product shall be operated in one round of the
whole procedures without the clothes inside.
It is recommended to calibrate the appliance in order to ensure optimum operation:
Empty the washing machine.
Plug it in.
Turn the appliance on and press Speed and Delay at the same time within 10 seconds. The
display will show "t19".
Press the Start/Pause button. The display will show "****" and the calibration process will
begin.
46