Fiem Cip Cip 28 Manual De Uso página 17

The metallic plate fixed on the machine is an integral part of the same; all serial numbers, and product
specifications are detailed on the plate.
THE FOLLOWING HARMONIZED RULES HAVE BEEN UTILIZED FOR THE CORRECT IMPLEMENTATION OF
THE ESSENTIAL REQUIREMENTS OF HEALTH AND SAFETY OFTHE ATTACHED I.
• EN 55014-1: 2006
• EN 55014-2: 1997+A1:2001
• EN 61000-3-2: 2006
• EN 61000-3-3: 1995+A1:2001+A2: 2005
• EN 60335-2-71:2003+A1:2007
Guanzate
TROUBLE SHOOTING CHECK LIST
Before asking for a technical assistance service, please follow this list to try to solve most common problems:
PROBLEM
The machine does not work
Working temperature
not sufficient
Egg-turner device not
working properly
Forced ventilation
not sufficient
Thermometer alcohol
column interrupted
Whichever reparation attempt not included on above mentioned form is severably forbidden.
Contact always the manufacturer or the authorized technical assistance in your country.
tel. 0039 031 / 97 66 72, fax.0039 031 / 899163 oppure il punto vendita autorizzato.
www.fiem.it - www.fiem.eu – emails: fiem@fiem.it – incubators@fiem.it – info@fiem.it
2
The working of the fan will be checked by sight, its bad working could compromise incubation results
The Declarer
CAUSE
Lack of power
Plug disconnected
Safety fuse burnt
Heating element not correctly
working
Thermostat not calibrated
Thermostat faulty or not working
Door open
Cold room under 17/18°C
Egg-turner motor broken
Egg-turner motor disconnected
connecting paragraph
Fan not working 2
Accidental drops or jarring
of the thermometer
SOLUTION
Check the plug
Put the plug into the socket
Replace the fuse
Contact the manufacturer
See instruction for calibration
Contact the manufacturer
Close the door
Place the incubator in a warmer room
Contact the manufacturer
See egg-turner motor
Contact the manufacturer
Try to put the thermometer
at low temperature (in a freezer)
for few minutes, and then allow
to return to room temperature.
Otherwise replace the
thermometer
17