Publicidad
Idiomas disponibles
Idiomas disponibles
Maintenance and cleaning
All cleaning of all parts must be carried out with the Thermostove completely
cold and unplugged to avoid burns and thermal shock. The Thermostove does
not need much maintenance if used with certifi ed quality pellet. The need for
maintenance varies depending on the conditions of use (switching on and off
repeatedly) and depending on the performance required.
periodic monitoring of the Thermostove to check its condition.
Parts
Brazier
Cleaning the ash collection
compartment with suction device
Cleaning ash tray
Door and glass cleaning
Exchanger (turbulators)
Flame beater
Cleaning the interior heat exchanger /
smoke fan compartment
Cleaning complete exchanger
Clean "T" to exhaust
Flue
Door gasket ash
Internal parts
Flue pipe
Circulation pump
Plate heat exchanger
Hydraulic components
Electromechanical components
◊ by the user / • by the authorised qualifi ed technical assistance
BY THE USER
Daily control
The Thermostove requires a simple and thorough cleaning in order
to ensure a more ef cient performance and smooth operation.
Every 2-3
Everyday
days
◊
◊
◊
◊
◊
◊
While cleaning the inside of the Thermostove, to prevent the
escape of ashes, you can start the fan ue exhaust. To enable this
feature, you must press the button
The display shows "PU L ST UF" (cleaning Thermostove).
To stop the fan, simply press and hold the button
completion of a cleaning cycle (255 seconds). Clean the grate using
the appropriate tool from the ash and any incrustation which could
obstruct the passage of air. In the case of depletion of pellets in
the tank may accumulate unburned pellets in the burn pot. Always
empty the residuals from the grate before each start. Remember
that only a brazier located and clean properly can ensure ignition
and optimal operation of your Thermostove. When positioning the
crucible, carefully check that the ends of the pads completely
adhere to their home and that the hole with pipe dedicated to the
passage of the resistance. There should be no residual combustion
in the contact zone between the edges of the crucible and the
support surface on the door crucible.
Every
Every 15
Every 30
week
days
The decreased or absent cleaning can
cause misfi re and cause damage to the
thermostove and the environment (possi-
ble emissions of soot and unburned). Do not pour
the pellets may be present in the brazier to misfi re.
It is recommended
Every 60-
Every 1
days
90 days
year
•
•
•
and then .
or wait for
•
•
•
•
•
•
•
•
79
Publicidad
