KRESS KG757E Manual De Instrucciones página 13

Assembling the grass collection bag to the lawn
mower (See Fig. B1, B2, B3)
NOTE: Depress the grass collection bag slightly to
ensure that it is completely installed.
Removing/emptying grass collection bag (See
Fig. C1, C2)
WARNING! Always check the safety flap close
the discharge outlet before using. Never lift the
safety flap when the lawn mower is being used without
fitted grass collection bag.
Installing the rear side-discharge chute（Sold
Separately）(See Fig. D)
Removing grass collection bag, then install rear side-
discharge chute in.
Installing the mulching insert (See Fig. E)
Removing grass collection bag or rear side-discharge
chute, then install mulching insert in.
Checking the battery charge condition (See Fig.
)
F1
NOTE: Fig. F1 only applies for the battery pack with
battery indicator light.
The battery level can be determined by pressing the power
indicator button beside the battery lights. Press the button
before and after each use to check the battery
Remarks LED-light
Five green
lights are
.
illuminated
Four green
lights are
illuminated.
Three green
lights are
illuminated.
Two green
lights are
illuminated.
One green
light are
illuminated.
No light is
illuminated.
Battery condition
70% ≤ Power level≤100%
50% ≤ Power level < 70%
35% ≤ Power level < 50%
20% ≤ Power level < 35%
10% ≤ Power level < 20%
Power level < 10%
Charging the battery pack (See Fig. F2)
- Your battery pack is partly charged and needs to be fully
charged before first use.
- More details can be found in charger's manual.
Installing & removing the battery pack (See Fig.
F3, F4)
Insert the safety key before installing battery pack(s).
NOTE: Depress the battery release button to release
battery pack(s) from your tool. After recharging, insert
the battery pack into tool's battery port until you hear
a "click". A simple push and slight pressure will be
sufficient.
Checking the power indicator light (See Fig. F5)
Press the switch button for battery indicator light and the
power indicator light will be on .
OPERATION
Starting and Stopping (See Fig. G1, G2)
Press the Safety lock-out button, then push Operating
bail to start. Release the operating bail to stop.
For starting, press both the Safety lock-out button and
the Operating bail at the same time.
Operating the self-propel system (See Fig. H)
Press the Safety lock-out button,
propel speed-control lever to operate.
NOTE: To activate self-propel, press both the Safety
lock-out button and the Self-propel speed-control lever at
the same time.
MULCHING MOWING TIPS
While mulching, your new mower is designed to cut the
grass clippings into small pieces and distribute them
back into the lawn. Under normal conditions, the mulched
grass will biodegrade quickly and deliver nutrients to the
lawn. Please review the following recommendations for
optimum mulching performance.
1) Avoid mowing when the grass is wet from rain or dew.
Wet grass may form clumps which interfere with the
mulching action and reduce the runtime. The best
time to mow the grass is in the late afternoon when
the grass is dry and the newly cut area will not be
exposed to direct sunlight.
2) For the best mulching performance, set the cutting
height to remove about one third of the grass blade
length, ideally no more than 40mm at one time. If the
lawn is overgrown, it may be necessary to increase
the cutting height to reduce the pushing effort and
prevent overloading the motor. For extremely heavy
mulching, it is advisable to first cut at a high cut
height setting, and then re-cut to the final cut height.
Otherwise, make narrower cuts and mow slowly.
3) For the best performance, keep the mower housing
free of built-up grass. From time to time turn off
mower and wait for the blades to come to a complete
stop. Then unplug the safety key, remove the batteries
and turn mower on its side. Using an object such as a
stick, wipe out any accumulation of grass around the
blade area. Be careful of the sharp edges of the blade.
Ensure to clean the blade area often when cutting
wet or new grass and every time after the machine is
used.
4) Certain types of grass or grass conditions may
then push the Self-
13
EN