Publicidad
Idiomas disponibles
Idiomas disponibles
Instructions
On/Off
Press and hold the
button to turn on the
robot. The power indicator will turn on and
the robot will enter standby mode. Press
button to turn off the robot
and hold the
and complete the cleaning cycle.
Note: The robot cannot be turned off when it is being charged.
Starting Cleaning
Press the
button to start cleaning. The
robot will plan its cleaning route according
to its scan of the room. It splits a room
into zones, first draws out zone edges, and
then fills the zone in a zigzag pattern. In
so doing, the robot cleans all zones one by
one, efficiently cleaning the house.
Zone 1 –
Cleaned
Zone 4 –
Next Zone
Notes:
• To allow the robot to automatically vacuum and return to
the dock, start the robot from the dock. Do not move the
dock during cleaning.
• Cleaning cannot start if the battery level is too low. Allow the
robot to charge before starting cleanup.
• If cleaning is completed in less than 10 minutes, the area
will be cleaned twice.
• If the battery runs low during the cleaning cycle, the robot
will automatically return to the dock. After charging, the
robot will resume where it left off.
Spot Cleaning
Press and hold the
cleaning.
Cleaning range: The robot cleans a 1.5 m
(4.9 ft) x 1.5 m (4.9 ft) square area centered
on itself.
Emptying
Auto-emptying will begin when the robot
returns to the dock after cleaning. Press the
button to trigger emptying manually.
Press any button to stop emptying.
Notes:
• The status indicator light turns off automatically when the
robot is charging.
• Do not use without dustbin cover or dust bag.
• Place the dock on a flat floor away from fire, heat, and water.
Zone 2 –
Avoid narrow spaces or locations where the robot may be
Cleaned
suspended in the air.
• Placing the dock on a soft surface (carpet/mat) may cause
the dock to tilt over and cause problems docking and
departing.
• Keep excess power cable inside the storage slot so that the
robot will not get tangled in the cables, and the dock will not
be dragged away or disconnect from the power supply.
• Keep the dock away from direct sunlight or anything that
Zone 3 –
may block the dock location beacon; otherwise, the robot
In Progress
may fail to return to the dock.
• The Auto-Empty Dock recharges and empties. Store the
standard robot dock before use. Failure to do so may cause
issues returning to dock.
• Maintain the dock according to the maintenance instructions.
Do not clean the dock with a wet cloth.
• Avoid frequent manual emptying.
Pause
When the robot is running, press any button
to pause it, press the
cleaning, press the
to the dock.
button to start spot
Note: Placing a paused robot on the dock manually will end
the current cleanup.
Sleep
If the robot is paused for over 10 minutes, it
will go to sleep, and the power indicator will
flash every few seconds. Press any button to
wake the robot up.
Notes:
• The robot will not go to sleep when it is charging.
• The robot will automatically shut down if left in sleep mode for
more than 12 hours.
DND Mode
The default Do Not Disturb (DND) period is
from 22:00 to 08:00. You can use the app to
disable the DND mode or modify the DND
period. When DND mode is activated, the
robot will not automatically resume cleanup,
the power indicator light will dim, and the
volume of the voice prompts will lower.
Charging
After cleaning, the robot will automatically
return to the dock to charge.
In Pause mode, press the
send the robot back to the dock. The power
indicator will pulse as the robot charges.
09
button to resume
button to send it back
button to
Publicidad
