Jocel JPIC007476 Manual De Instrucciones página 54

7. Buzzer will bips for 30 seconds and the timer indicator shows "--" when the setting time
finished.
Setting the timer to switch off the required heating area
1. Select the cooking zone by touching the zone you want to set the timer and select the
power level, touch the button of the timer then touch the timer sensor, use the sensor
slider to confirm the action.
2. Set the time by touching the control of the timer.
Note: Move the slider from low to high, to increase or decrease the time.
3. If the setting time exceeds 99 minutes, the timer will automatically return to 0 minute.
4. When the time is set, it will begin to count down immediately. The display will show the
remaining time and the timer indicator flash for 5 seconds.
5. Moving the sensor slider to the left, the timer turns off.
6. When the set time expires, the corresponding timer will automatically turn off the heating
zone.
Note: The red dot next to power level indicator will illuminate indicating that zone is
selected.
COMBI AREA (COMBI DUO)
•
This area can be used as a single zone or as two different zones, accordingly to the
cooking needs anytime.
•
Flexible area is made of two independent inductors that can be controlled separately.
When working as a single zone, the part that is not covered by cookware is automatically
switched off after one minute.
•
To grant a correct pan detection and a even heat distribution, the cookware should be
correctly placed:
- In the front or rear side of the flexible zone when the cookware is smaller than 22 cm
- Anywhere with bigger cookware.
COMBI AREA (COMBI DUO) - As big zone
1. 1.To activate the flexible area as a single big zone, simply press the dedicated keys.
2. 2.The power setting works as any other normal area.
3. 3.If the pot is moved from the front to the rear part (or vice versa), the combi area detects
automatically the new position, keeping the same power.
4. 4.To add a further pot, press again the dedicated keys, in order to detect the cookware.
53