Emos E5059 Manual De Instrucciones página 26

K – SEARCH button
L – stand
Description of the Multifunctional Sensor and Battery Charger (see Fig. 2)
1 – wind direction paddle
2 – wind sensor cups
3 – cover of the temperature and humidity
sensor
4 – mounting rod
5 – LED indicator
6 – TX button
7 – rainfall cover screw
8 – rainfall cover
Mounting the Sensor onto a Wall (see Fig. 3)
List of Cities (see Fig. 4)
Getting Started/Installation
1. Plug the power adapter into the station, then insert batteries first into the weather station (3×
1.5 V AAA) and then into the outdoor sensor. The battery compartment of the sensor is protected
by screws; use a suitable screwdriver.
2. When inserting the batteries, make sure to observe the correct polarity to avoid damaging the
weather station or sensor. Only use alkaline batteries of the same type. Do not use rechargeable
batteries in the weather station.
3. Place the two units next to each other. The weather station will automatically start searching
for sensor signal within 3 minutes. To speed up the pairing process, you can press the TX button
on the sensor (red LED will flash).
4. If the signal from the sensors is not detected, long-press the SEARCH button on the weather
station to repeat the search and press the TX button on the sensor.
5. To ensure correct measurement, the sensor must be placed higher above the ground (at least
1.5 m) on a horizontal surface outside of buildings and structures. The sensor must be mounted
firmly to prevent its damaging. First screw the mounting rod onto a wall, then screw the sensor
onto the rod according to the figure Mounting the Sensor onto a Wall. Wind must flow freely
around the wind sensor from all sides. Check that the wind direction indicator and paddles for
measuring wind speed can rotate freely. The north (N) indicator on the front of the sensor must
be pointing north. Otherwise, wind direction will always be displayed incorrectly. When choosing
a suitable place for mounting the sensor, check before installation that the main station is within
range of the sensor. The range of the sensor may decrease substantially in areas with a large
number of obstacles.
6. Do not place the sensor onto metal objects; this would reduce its transmission range.
7. If the low battery icon appears on the screen, replace the batteries in the weather station or
recharge the battery in the sensor using the enclosed charger.
Recharging the Sensor Battery
1. Place the battery from the sensor into the USB charger. When inserting the battery, make sure
to observe the correct polarity to avoid damaging the battery.
2. Plug the USB-A connector on the charger cable into an adapter (not included) or another device
that will supply power to the charger. Make sure the adapter is plugged into a socket or the
device receives sufficient power.
3. If connected correctly, the charger will start recharging the battery.
4. Charging is indicated by a red LED. Fully charging the battery takes approximately 10 hours.
5. When the battery is fully charged, a green LED will light up.
Note: the sensor features an integrated solar panel that continuously recharges the battery. Charging
speed is dependent on the intensity of sunlight – it serves only as supplementary charging. In the
winter, it is recommended to always recharge the battery using the enclosed USB charger.
M – battery cover
N – connector for power adapter
9 – battery compartment cover
10 – water-level
11 – rainfall dish
12 – UV radiation sensor
13 – solar panel
14 – north indicator
15 – battery charger USB connector
16 – battery compartment
26