BUTSIR URUMA Manual De Instrucciones página 22

Dented or rusted propane cylinders may be hazardous and should be checked by your propane gas sup-
●
plier.
LP gas tank must be arranged for vapour withdrawal.
●
The LP gas tank must have a tank collar to protect the tank valve.
●
Never use an LP gas tank with a damaged body, valve, collar, or footing. Dented or rusted LP gas tanks may
●
be hazardous and should be checked by your LP gas supplier prior to use.
The LP gas tank should not be dropped or handled roughly.
●
Tanks must be stored outdoors out of the reach of children. Do NOT store in a building, garage, or any
●
other enclosed area.
Never store your LP gas tank where temperatures can reach over 125°F.
●
Do not store the LP gas cylinder in direct sunlight or near a source of heat or combustion.
●
Never keep a filled LP gas tank in a hot car or car trunk. Heat will cause the gas pressure to increase,which
●
may open the relief valve and allow gas to escape.
Place dust cap on valve outlet whenever the LP gas tank is not in use. Only install the type of dust capon
●
the LP gas tank valve outlet that is provided with the LP gas tank valve. Other types of caps or plugs may
result in leakage of propane.
Do not store a spare LP gas cylinder under or near this appliance.
●
If the information in (a) and (b) is not followed exactly, a fire causing death or serious injury may occur.
●
LP gas cylinders should be filled only by a certified LP gas dealer.
●
The pressure regulator is set for 28-30mbar or 50mbar.
●
Regulator outlet pressure is 28~30mbar or 50mbar.
●
Never attempt to attach this appliance to the self-contained LP gas system of a camper trailer, motor
●
home or house.
Always use the pressure regulator and hose assembly provided with the appliance to connect to a LP gas
●
cylinder. Never connect to an unregulated LP gas supply.
Contact your retailer's customer service department for replacement parts.
●
Hand turn the manual gas control valve. Never use tools. If the valve will not turn by hand, do not try tore
●
pair it. Call a certified gas technician. The use of force or any self-attempted repair may result in a fire or
explosion.
Use only the type of gas and the type of LPG cylinder specified by the manufacturer.
●
Appliance is fitted with gas regulator, flexible gas rubber pipe and clamps according to the National Rules
●
in force of the country of destination.
Appliance must use an approved gas regulator (approved for a working temperature not lower
●
than 50˚C) according to the EN Standard (see minimum, nominal and maximum pressure - gas
regulator inlet and outlet connection according to the National Rules in force) and flexible gas
hose according to EN Standard (with proper inner diameter according to gas inlet connection and
National Rules in force) with a length not over 1.5 m and approved for a working temperature not
lower than 60˚C. When substitution will be necessary, you have to purchase suitable gas regulator,
flexible gas rubber pipe and clamps from your local gas dealer; gas regulator should be substitut-
ed not over 10 years.
Flexible gas rubber pipe must be carefully, avoiding any twisting. Never use a damaged gas regulator.
●
Never connect this appliance to an unregulated LPG source (gas regulator is mandatory to be used).
●
22