BUTSIR URUMA Manual De Instrucciones página 26

Instructions for connecting the gas circuit to the LPG
bottle and replace:
Have a suitable star screwdriver, adjustable wrenches and pliers handy. The gas regulator, exible rub-
ber tube and clamps are not supplied with this appliance. Use only those recommended by the man-
ufacturer, in accordance with current national standards.
The LPG bottle must be exclusively a BUTSIR PRO bottle, 5 kg propane.
Be careful: do not bend the gas rubber tube. The gas en-
try connection is in line with ISO 7-1 or ISO 228-1 stand-
ards, in accordance with the National Rules in force in the
country.
Make sure the gas control of the appliance is set
●
to "OFF".
Connect the hose to the conical connection
●
of the garden fire and tighten the flange with a
screwdriver (see Figure 5).
The diameter of the hose is small so it is expen-
●
sive to insert it.To facilitate this it is recommended
to take a container with very hot water and sub-
merge the end of the hose (downwards so that
no water enters), for one minute.This dilates the
hose and is much easier to insert it to the end.
Do the same with the controller connection.
●
Connect the regulator to the LPG bottle by
●
threading with your hand (See figure 6).
OPERATING INSTRUCTIONS
LIGHTING
Make sure the fireplace is stable and in solid state.
●
Remove the protective cover.
●
Press the control button fully until you hear a slight ticking sound (this is the piezo ignition). If you
●
hear nothing when pressing the ignition button, then you probably need to replace the battery.
Hold the control knob pushed in when you open the gas supply. Turn the control knob to the right
for gas supply. The burner shou ld now ignite within 15 seconds. If the burner gives a completely
flame, you hold the control knob for 15 seconds withheld. If burner does not light, wait 5 minutes,
repeat. The flame continues to burn. Extinguishes the flame, try this again and hold the button
long erretained.
26
5
6