Argo ISIDE Instrucciones De Uso página 26

Connect the power cord to a suitable electric socket (220–240 V). Insert the supplied batteries into the remote control
and make sure the poles match. Select the desired operating mode from the remote control.
Avoid tight bends or folds in the hose.
If the air conditioner is not used for prolonged periods, disconnect the pipe and plug the window unit.
This appliance can be used for cooling, dehumidifying and ventilation purposes.
Before using the appliance, leave it standing erect for at least two hours.
When switching between modes, the fan continues to turn but the compressor stops: the compressor will re-start after 3
minutes. This delay protects the compressor from potential damage.
This appliance is equipped with an automatic defrosting system. When the appliance starts defrosting, the Power LED
flashes on the control panel. In cooling and dehumidification mode, the compressor stops for 10 minutes, after which the
appliance continues to operate regularly.
Cooling, Fan
THE DRAINAGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the
appliance is used in dehumidification mode only, in which case the appliance should be left to discharge directly
into the room for maximum efficiency (see the "Dehumidification Mode" paragraph).
Clean the air filters under the easily removable rear grille regularly to keep the air conditioner working efficiently.
V 12/20
HOW TO USE THE APPLIANCE
Dehumidifying
26