Argo X3MI ECO 52SHB Manual De Instalacion Y Uso página 77

Cleaning the filters
Open the panel
Lift the front panel of the indoor unit, as shown.
Clean the filters
• Use a vacuum cleaner to clean the filters.
• If they are very dirty, use water (below 45°C)
and leave to dry in a cool, dark place.
N.B.:
The filters should be cleaned every three months, or more frequently if the room is very dusty.
WARNING!
When you remove the filters, avoid contact with the heat exchanger (there is a risk of
cuts or abrasion).
Do not use a hairdryer to dry the filters; the heat can cause damage and warping.
Before-use checks
1. Check that the air inlet and outlet are free of obstructions.
2. Check that the circuit breaker, plug and socket are in good working order.
3. Check that the filters are clean.
4. Check that the outdoor unit's support bracket is not damaged or corroded. If it is, contact the
service centre.
5. Check that the piping is not damaged.
After-use checks
1. Disconnect the power supply.
2. Clean the indoor unit's panel and filters.
3. Check that the outdoor unit's support bracket is not damaged or corroded. If it is, contact the service
centre.
N.B.
4. Many packaging materials are recyclable materials. Please dispose of them in the
appropriate recycling unit.
5. If you want to remove the air conditioner, please contact your local dealer or local service
provider for the correct disposal method.
TROUBLESHOOTING
Possible faults and solutions
WARNING
Do not attempt to repair the unit yourself. Improper repair can cause electric shocks or fire. Disconnect
the unit from the power supply before contacting your local Technical Service Centre.
Carry out the following checks before contacting your Technical Service Centre:
V 01/20
Remove the filters
Remove the filters by lifting one of the
bottom corners and
downwards, as shown.
Refit the filters
Refit the filters and close the front panel.
pulling them
77